•
The ESSENTIAL KEY TO STARTING A WATER TREATMENT
PROGRAM so that full benefits can be realized
for corrosion prevention is metal passivation
and pretreatment cleaning. Now you have the ability
to get your program started on the right foot.
•Prepares surfaces so that treatment will
“take”;much like seasoning a cast
iron skillet or griddle
•Product is formulated based on successful
industrial research and development of chemical
metal passivation
•Cleans out all the manufacturing grime
and gunk that will later be problematic for your
new boiler and a successful water treatment program
•Works well to prepare “neglected
“ boilers for a new treatment program
•Inexpensive and easy to use
•Necessary process after any form of system
scale removal to halt these aggressive processes
•Has the ability to really “scrub”
and penetrate
•Without this process you are really handicapping
any regular treatment’s ability to provide
full corrosion protection
•Shelf life of 2 years
•Fully concentrated
Dosage: New boiler
- 1 quart per 200 gallons of system fill water. Existing
(used) boiler - 2 quarts per 200 gallons of system fill
water
Directions for use: Flush system with
fresh water and drain. Carefully mix Prep Solution 102™
in a clean 5 gallon bucket with 2-3 gallons of warm,
clean water. Refill boiler with fresh water adding entire
contents of your Prep Solution 102™ mixture directly
to boiler. Fire your boiler to warm system water to
assist product effectiveness and circulate for 4-12
hours. Completely drain and flush system. Caution for
existing (used) system: Heavily fouled systems may tend
to slough large amounts of deposited material; therefore,
adequate precautions should be taken to prevent plugging
of small lines, heat exchangers, etc. Scale
deposits should be removed prior to using Prep Solution
102™ for best results.
Back
To Top
